Home Maintenance HVAC, Plumbing Tactics Reduce Emergencies

Your water heater is one that is used and more appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating and energy costs.

Regular flushing of the water heater is among the single most important step you can take to prolong its service life this particular save energy. For time, sediments strengthen in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regarding the country, the common water heater lasts 3-5 years. Regularly flushing your hot water heater can double daily life of your water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is in today’s economy. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a month or so.

To drain your water heater, initially you should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it is definitely an electric heater). Failure to do so could result in overheating and severe damage to the water heater. Next, close the water supply valve located in the water inlet line going into your water heater. After backing up connect a garden hose to the drain valve located in the bottoom of the space heater. Open the drain and allow it to play until all for the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the hot water heater. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until the water flows out smoothly. This will allow air to vent inside heater and the water lines. Finally, you can turn the thermostat back to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your residence to filter or condition the water so is certainly less corrosive to your plumbing system, particularly in areas possess hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in region to discuss options and merchandise to be fitting.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2

Bookmark the permalink.